John LewisHot Water Bottle and Cover

Cuddle up and get cosy with this faux fur-covered hot water bottle. Soft to the touch, warm and comforting when filled, it's perfect for chilly Autumn nights in bed or on the sofa.

Cover 80% acrylic, 20% polyester. Size L60 x W30cm

The hot water bottle is made from PVC, and manufactured to BS1970:2012

When filling this hot water bottle, do not use boiling water and fill to a maximum of two-thirds capacity or less. Do not overfill as this might cause the bottle to burst. Hold the bottle by the neck in an upright position and fill slowly to avoid hot water splashing back. Expel air from the bottle by lowering it carefully onto a flat surface until water appears at the opening.

Screw the stopper sufficiently tight to ensure that there is no leakage. Finger-tight should be adequate. Finally, make sure the funnel is empty. If there is a possibility that prolonged contact with the skin could occur, an adequate cover should be used to prevent burns. Under no circumstance should the hot water bottle be used as a cushion and be sat on.

Do not fill using water from the domestic hot water system as this can considerably shorten the life of the hot water bottle. Prevent contact with hot surfaces. Prevent contact with oil or grease.

When not in use, drain completely and keep, with the stopper removed, in a cool, dry, dark place. Prevent exposure to sunlight. Do not place anything on top of the bottle during storage. Check the bottle and stopper for wear and damage prior to use.

WARNING - HOT WATER BOTTLES CAN CAUSE BURNS. AVOID PROLONGED DIRECT CONTACT WITH THE SKIN

Retain these instructions for future reference.